Articles

Power Splitters and Combiners, 2 To 30 MHz, Type "HF"

     These RF power splitters and combiners are intended for combining the powers of multiple amplifiers having 50 ohm inputs and outputs. Power balancing resistors, which are necessary to maintain operation at reduced power if one or more amplifiers fail, are not included but provisions are made to include them. Without these resistore, the power output will be zero in the event of a failure. 

 

Click picture (below) for larger view

hf2portaLarge

2-port splitter-combiner (above) with power handling capability up to 600 W

Click either picture (below) for larger view

hf2portbLarge

hf2portcLarge

2-port power splitter-combiner (above with schematic) with power handling capability up to 1000 W

Click either picture (below) for larger view

hf4portaLarge

hf4portcLarge

4-port power splitter-combiner (above with schematic) with power handling capability up to 1200 W

Click picture (below) for larger view

hf4portbLarge

 4-port splitter-combiner (above) with power handling capability up to 2000 W

 Key Benefits:

  • 50 Ohm interface on all ports
  • 30 dB minimum isolation between splitter output and combiner input ports
  • VSWR guaranteed less than 2:1 for 2 to 20 Mhz

     Available from stock, depending on quantity (3-port systems available on special order). Contact us about your special requirements and our low prices.


 

newrflogo


8280 W. Avenida Del Sol  Peoria, AZ  85383   Phone: 623-376-7720   FAX: 623-376-7721
 

Since 1986

This email address is being protected from spambots. You need JavaScript enabled to view it.